Assembly 
Instructions Pt3
6) Attach remaining corner strip with lip facing inward. Slide the lip of the corner strip under the starting strip until the sides meet. Make sure the top of the corner strip is flush with the top of the starting strip and insert a screw into the groove of the starting strip through BOTH pieces.* Do not insert another screw yet on this corner strip.
7) Insert the first slat wall panel by placing it 90 degrees to the starter strip, push in, and snap down. Drive a screw through the plastic (in the groove) and directly into each stud.
8) Continue adding panels until finished, ending with the finishing strip and you're done!
QUESTIONS?
Give us a call
616-844-4211