Assembly Instructions

A Unislat Wall is easy to put up... Simply screw in the starting strip, snap in a panel and screw it down, repeat until you get to the bottom and snap in the finishing strip. There are no brackets and the screws are invisible when finished.

1) Place the starting strip between the outer studs/markings in the desired location and insert a screw in a middle stud. The slat wall has a groove in it to start the tip of the screw. No pre-drilling is required (except in concrete applications).

2) Scribe a level line horizontally where you want your Organizer to start. Identify the stud locations and mark or draw a line 47” down.

3) Level the starter strip and insert the other middle screw.

Continued...     >>>>